Installation of pre-hung shutters
- Assemble the frame
- Pre-drill holes 1/8" in diameter at each hinge location (in the light stop) on the vertical frame pieces and as needed on the horizontal pieces.
- If size allows, place panels in the assembled frames
- Set the frame in the window, after leveling the sill or header secure hinge side, starting with the top hinge of the opening with a square drive trim screw **see drawings below for penetration point and screw size**
- Place panels in the frames (if not done at step 3)
- Close panels to check fit and see if any shimming and adjusting is necessary
- Complete fastening unit in opening, hinge side first, then magnet side - taking care to keep frame legs straight
- Adjust frame for square - note the diagram below
- Cover screw holes with putty or screw caps. Use touch up paint to blend when needed.
Click for larger version
